c
CLCM-0905C-250 CLCM-0905C-400 CLCM-0905C-251 CLCM-0905C-102 CLCM-0905C-202 CLCM-0905C-472 CLCM-0905C-652 E General information:It is recommended that the temperature of the part does not exceed 125°Cunder worst case operating conditions.?Ambient temperature: -40°C to +85°C (refering to IR) ?Operating temperature: -40°C to +125°C?Storage temperature (on tape & reel): -20°C to +40°C; 75% RH max.?Test conditions of Electrical Properties: 20°C, 33% RH if not specified differently All recommendations according to the general technical specifications of the data sheet have to be complied with.The disposal and operation of the product within ambient conditions which probably alloy or harm the wire isolation has to be avoided.If the product is potted in customer applications, the potting material might shrink during and after hardening. Accordingly to this the productis exposed to the pressure of the potting material with the effect that the core, wire and termination is possibly damaged by this pressure andso the electrical as well as the mechanical characteristics are endanger to be affected. After the potting material is cured, the core, wire andtermination of the product have to be checked if any reduced electrical or mechanical functions or destructions have occurred.The responsibility for the applicability of customer specific products and use in a particular customer design is always within the authority ofthe customer. All technical specifications for standard products do also apply for customer specific products.Cleaning agents that are used to clean application might damage or change the characteristics of the component, body or termination. Direct mechanical impact to the product shall be prevented as the ferrite material of the core could flake or in the worst case it could break.Product specific:Follow all instructions mentioned in the datasheet, especially:?The soldering profile has to be complied with according to the technical reflow soldering specification, otherwise no warranty will be su-stained.?All products shall be used before the end of the period of 12 months based on the product date-code, if not a ** solderability can′t bewarranted.?Violation of the technical product specifications such as exceeding the nominal rated current will result in the loss of warranty.